Plank hardwood floors of inlaid parquet staves width of 35-90 mm, thickness 12-20 mm, length 150-500 mm; inlaid or mosaic parquet, parquet and boards. Parquet (riveting) are made of oak, beech, maple, ash and other solid wood. Rivets are fixed to the base directly on the site or the boards at the factory. Inlaid mosaic parquet comes to the site pasted face down on paper, which after laying parquet floor at the base removed. Parquet boards and panels have two layers: the bottom – of a thickness of 25-27 mm strips, glued together, and the upper – of parquet planks 6-8 mm thick, glued with water resistant adhesive to the base. Along the lateral edges parquet make tongue and groove, and the front side of the planed and sanded.
Parquet panels produced with a side of the square of 400-600 mm, and the parquet boards are of length 1200, 1800 and 3000 mm, width 140-150 mm. The ground under the piece, inlaid and mosaic parquet flooring can serve as a plank of softwood a thickness of 35-40 mm or concrete, cement, sand and asphalt tie, and a parquet boards, wood joists. Before laying your flooring carefully examine substrate moisture content, cleanse it from dust and cover the bituminous primer (solution of bitumen in gasoline or kerosene in a ratio of 1:3). Hardwood dowel sorted by color and thickness. One of the important conditions that determine the quality of the parquet, is humidity parquet parquet boards and staves, which should be within 6-10%. During the work on the parquet flooring humidity in the room should not exceed 60%. From the parquet can spread a variety of designs, it placed with a frieze without him. Inlaid parquet floors of parquet flooring in the not adjusted to the walls and partitions up to 15 mm.
Parquet plank begin with a number of lighthouse, which we carefully placed on the cord. Cold bitumen mastic is spread on the basis of Primary coated, using a serrated paddle. The width of the bands of mastic around 60 cm thick layer should not exceed 1 mm. Mastic is placed on a riveting, squeezing out part of mastic in stitches, unite them with a hammer, which hit the wooden staves through a special gasket. Parquet directly on both sides of the lighthouse series while watching the tight junctions and planks to each other. Inlaid parquet plank cards, harvested at the factory, order the same labels. Parquet panels are placed on a pre-packed sleepers, to which they are attached with screws. Tighten the screws into the prepared hole – deeper into billboards. Then, these deepening obscure putty-colored parquet. Parquet boards often overlapping plank on buildings, combined in a tongue and groove and nailed to the sleepers. Parquet board placed perpendicular to the sleepers, are combined in a groove and firmly unite. Boards are fixed to each lag nails, a length of 60 – 70 mm. Hammer nails into the base pan bottom cheek groove on the edge of the floorboard, and seek doboynikom. Hammer nails into the front surface of the boards is prohibited. Mechanical joints of parquet boards should be placed on the joists. Finish parquet floors. After graduating from parquet flooring start its , which operates parquet-shaving machine. Before parquet redoubt of very hard rocks its surface lightly moistened with water. After redoubt parquet polished floor polishers, in which as the abrasive material use abrasive cloth with a glass spreading. Hardwood planks and boards of prefabrication not require sanding. After grinding remove dust and the perimeter of the premises nailed baseboards or fillets.