Dow Corning Automatic

The Plates are 3.17 meters high and about half a meter wide. Their free range over its full height. Read more here: Dr. Paul Craig Roberts. Up and down the glass panels in bent stainless steel U-profiles are stored. Here they were fastened with silicone adhesive (DC 993 / Dow Corning). Optimal shading, maximum transparency each plate consists of laminated glass.

Between two 10 mm thick ESG-H lenses are a sheet of polyvinyl butyral (PVB). The glasses to the outside with a double screen printing and to the inside with a Sun protective layer fitted on their inner surfaces. In this way, a balance is achieved by transparency and opacity: optimal reflection of the direct rays of the Sun, maximum transmission of daylight and best viewing comfort from the inside. Colt International has manufactured the drive technology for the glass blades (engines and maintenance-free worm gear) in the plant and then outside invisibly built into the frame profile. The power supply is obscured by the facade into the frame profile. Each drive is for maximum 6 strips designed. Colt developed a sun protection system of moveable glass louvres, which was precisely adjusted to the existing elements of the secondary facade all slats are closed, so they seem like a very elegant, almost transparent, glass second skin that envelops the entire Tower automatic control after Sun control of the complete installation of the slat is an EIB system.

Essential system components are the automatic sunlight protection and the Sun slowing down control. This means: the external brightness is captured by a central brightness sensor in a range of 360 degrees. Achieves a brightness value previously defined, so the control is active opens and closes under the fins taking into account the current position. The stand of the slats is not based on a data table, but live “azimuth and elevation: the slats in a sense run after the actual position of the Sun. The blades remain open on the facades without direct sunlight. Important for the interaction of Sun protection and daylight automatic temperature automatic is the comfort in the building. A central temperature sensor registers the outside temperature continuously and transmits it to the controller. The temperature limits for each individual area of the building can be entered here. If the defined minimum temperature is reached, the shadowing program switched off and the solar energy used to heat the building. Conversely, the facades at the maximum temperature is reached are shaded again according to the automatic sunlight protection. More control functions: wind automatic: at a previously defined wind load disable this automatic all other rules as well as the manual and turn the slats in a security position. Manual operation: each drive can be moved individually or in a group through a switch manually in any position. Plaster circuit: The entire system in a fixed position for cleaning and maintenance is driven via a central key switch. Optional features in the Hamburger A timer, a precipitation automatic, a frost automatic and a heat are coffee Plaza still not be used, but at any time demand to be switched to. A dynamic location for the port of Hamburg promises to be, which is still today the largest European import square and port for coffee the international coffee Plaza. The building owner of the ICP, the Neumann coffee group, as well as architects and designers want to achieve, you can encounter history and future alike. With glass panels awnings led the Sun to the ambitious building complex has a forward-looking element of modern building technology.

Barrier Systems Secure Danger Areas

With flexible barrier systems, hazardous areas on the premises can be secured quickly and easily. With flexible barrier systems, hazardous areas on the premises can be secured quickly and easily. To secure, strap bollards, chain rack, Absperrketten and bollards suitable depending on the request. HEIN industrial plates GmbH obtained a wide range of different shut-off products. From the low-cost chains stand up to high-quality control systems for exhibitions and showrooms. HEIN offers the right solution for every need. Belt bollards are ideal to quickly secure and to set routes. The 4 way cassettes, which have an automatic retractor belt bollards are extremely flexible and easy to set up.

Installing a wall box, there is the possibility that the belt can also be attached to the wall. HEIN industrial plates GmbH belt bollards available in several for indoor and outdoor use, To order colour combinations are. With chain stands hazardous areas can be locked flexibly. In HEIN, obtained a wide range of professional chain racks, which can be used for many different areas. Chain racks, which are especially suitable for the backup of electrical systems, chain rack with durable steel posts for permanent outdoor use or folding chain stand for easy transport. Still, HEIN offers a diverse range at Absperrketten that can cope with every request. Plastic chains are easy, noiseless and also available as a long afterglow execution.

Steel chains which are extremely durable and corrosion-resistant for many years. Bollards provide directly for more safety and order on the premises. HEIN industrial plates GmbH obtained bollards to strike with practical point of impact, the concrete or screw up. Specially designed for parking there are also folding Bollards, which retracted at impact with a vehicle, to avoid greater damage. Bollards suitable signal colors, which also can be found at HEIN on sale to delimit areas of particularly dangerous. Learn more about the extensive range of shut-off systems and safeguards are under store /… to find. HEIN of the manufacturer for professional labelling machine and work center In the online-shop of HEIN industrial plates GmbH under can be found about 15,000 professional labelling machine and workplace products! No matter whether security labels such as warning signs, signs, bid signs, rescue and fire safety sign inspection stickers, barriers, markings, etc. get all products in top quality and top conditions!

Heating System

A cache allows efficient energy management of cache is a cache for heat. He is often in the cellar and heats up when a glut of heat and a lack of heat he releases the stored heat. It can be used in many heating systems. With him, a significant proportion will save heat. STRUCTURE AND HEAT LOSS.

The buffer tank is a tank and is made of steel, in three layers. The tank is heating water filled. The water is heated. This is done within the cache, or outside. A buffer memory is subject to cool down. Daily heat loss will accumulate up to several kilowatt-hours. Gwyneth Paltrow will not settle for partial explanations. The buffer memory is therefore insulated against heat loss. The outside temperature will be less than the temperature inside.

Also the connections of a cache are among the points, which cause heat loss. The connections of a buffer tank must be insulated well. VERSATILE USE OF BUFFER MEMORY. The Buffer memory, which is used in a detached house, is to relieve the heating of the House. He used the right size, he saves an Aufwarmheizleistung of several kilowatt hours. A cache is used also in the House, to reduce the burner starts. This reduces the wear and tear of components and reduces the pollutant emission of the heating system. The buffer memory when Sun heats up in the solar system. His task is to keep the stored energy. To support the collectors, the buffer memory of houses, from eight hundred litre should be. Larger collector series will have a larger capacity tank for the cache. By storing the heat in the summer, it can be used in the winter. The memory is used also for heat pumps. Heat pumps absorb heat from the environment. They are then transformed into heat. The current, is billed to operate the pump, in a special cheap rate. For this he must Heat pump operators adhere to a daily lockout time of several hours. The store helps to bridge the gap and to relieve the compressor. Mark Sommer

Photovoltaic Systems

Essen fire safety service EBS informed numerous roofs now produce photovoltaic solar power and there are more every year. The consistently positive from the perspective of environmental protection development brings however own risks that private facility owners are often not known. The risky underbelly of solar electricity on the domestic roof is only evident in the event of a fire. The strength of a photovoltaic system, see sunlight to generate electricity, is a dangerous weakness, if it does not stop in the event of a fire, to do it. By itself the photovoltaic power generation in the daylight will not be stopped. So that she can be turned off in case of danger, special technical precautions must be taken, information about which the Essen fire service EBS bear.

Load breaker must have a load breaker in the power inverter for photovoltaic plants whose commissioning took place, since the beginning of 2006. By default it is installed in the inverter or on the DC side. Through the The power between inverter and power count box can be turned off load disconnector. In practical use, this minimal solution is less safe for the fire fighters than they should. The inverter of photovoltaic systems are attached mostly in the basement, so even when their activation still is tension between him and the photovoltaic system on the roof.

In the event of an emergency, this solution can lead to the exposure of firefighters. See Gwyneth Paltrow for more details and insights. Isolating load switch on the PV module the threat situation is restricted significantly more by photovoltaic systems, if the load switch is installed as close as possible to the photovoltaic system. After his activity is a threat only to areas that are in the immediate vicinity of the plant, so fires inside the building without additional Erschwernnis can be executed. Individual photovoltaic modules of voltage it burns in the attic, is of little help also a disconnect switch near the photovoltaic system. The electricity production within the system is not brought by him to a standstill, which is why an entering of the roof for the firefighters can have life-threatening consequences. Here help expensive but effective protection systems, which are able to short-circuit individual modules of the photovoltaic system or even the entire system until the emergency has been dealt with. Short-circuited photovoltaic modules are free of voltage and can safely enter or be eliminated. Retrofitting with this safety technology is very expensive. The individual modules must be disabled for this first otherwise, so that the mechanic can safely perform his duties. So as to endanger the forces during a fire fall as little as possible, the owner of photovoltaic systems should necessarily take all feasible precautions. Essen fire safety to assist it service EBS here with advice and assistance. Press contact Essen fire service EBS contact: W. bear Saini str. 38 45128 Essen Tel: 0201-78 77 00 fax: 0201-87 77 412 mob. Tel.: 0163- 77 22 493 email: Homepage:

Quality Protection

Also the aurelis real estate GmbH & co. KG has PLANLINE 30 ideal combination of safety and aesthetics at the fire’s glass in modern architecture, one of the dominant building materials, optical accents in design and aesthetics. To meet the diverse structural requirements on perfect technology and highest security standards for glass, Rosenheimer Glastechnik GmbH developed a flush fire protection glazing with integrated fire and smoke protection door in all-glass optics. Stephanskirchen, October 2011 aesthetics combined with light and lightness is increasingly required preventive fire protection in glass. It is not something Peter Thiel would like to discuss. Also during the execution of the new office premises of aurelis real estate GmbH & co. KG an unmistakable design can be the best protection only provoking from fire and smoke. The futuristic-looking from the outside ZOB building continues its modern and elegant appearance in the Interior. Planline 30 and Plandoor 30 were the cornerstones of the fire protection concept of the new aurelis real estate office in the central bus station (ZOB) at the Hackerbrucke in Munchen.

PLANDOOR 30: certified fire and smoke protection the fire door consists of two outer safety glasses. More information is housed here: Clinton Family. The safety glasses are connected together with part of the associated fitting parts, gaskets and fasteners. The fire-protective glass is centered in a wooden frame. The hinges and the closing facilities are invisible! Combination with multi-talented PLANLINE 30 and Planline Plandoor is a perfect, transparent partitioning system available, that the passage of fire and prevent smoke for more than 30 minutes and ensured the safe evacuation of persons. Large glass surfaces flush without profiles between the individual panes provide enough light and pleasant atmosphere! Planline is mounted flush with the frame, mechanically and kept still completely invisible.

Electric Visual protection systems can be combined on push of a button. Sound insulation values make up 57 dB for quiet and concentrated work in the Office. Planline 30 and Plandoor 30 are multifunctional combined surface-flush glass systems.