If not drill in the workshop mechanic lover, you can make with their hands so the machine from scrap materials and components. Because of a technological breakthrough in photofission, obsolete hundreds of thousands enlargers. They are gathering dust in a closet and attics, and many simply did not hand up to throw them, because they look brand new, and often they are associated with pleasant memories. Of course, the magnifying glass can be unscrew, and the wire with socket for light bulbs used as portability. Not in such quantity, but lacking in the same places of storage for items that throw a pity, household whisk – mixers, in which plastic worm gear drive is erased.
Of course, if you set a cap-grinder, throw, normally, not in a hurry, though, and pray for coffee or sugar in the attachment of a new mixer. Of the details outdated enlarger and a half Broken mixer is quite possible to build small, you want an amateur studio, drill. Enlarger is taken from a table-base with a reception at which the vertically moving carriage with a lamp, lens, and etc. And from the mixer – electric motor with a system of change of velocity (speed or smoothly varying). The first thing to wear on the motor shaft chuck for drills with a diameter of about 6 mm. Carved on its own bushing with the Morse taper is problematic, so you can order this item. Everything else can be done in not very equipped workshop.
Pliers, wire cutters, bolts, nuts, screwdrivers, wrenches, etc. – there have Designers enthusiasts. Yes, and calipers to measure – not a rarity in their workshops. Screw the motor to the carriage enlarger can be in different ways, depending on their structural features. Can use, or a rectangle of sheet aluminum or Plexiglas, or press the motor yoke of tin (preferably stainless steel tank from Soviet washing machine). Not far from the bar magnifier can be Screw the box with the switch and switch speed mixer, from which one side goes the cable for connection to an electrical outlet, preferably with a grounding wire. The second flexible cable with a length designed for maximum lift carriage, is connected to the motor and presses the ink cartridge clamp. Depending on the electrical mixer, cables needed to 5-6 wires. Setting up a homemade drill the machine is reduced to equalize the vertical axis along which the drill will move up and down. You can further screw beneath the point of lowering the drill small gripe, but in extreme cases – clamp, for which screwed to the table a special corner.